« Smart Surface | Main | Initial Renders with 'Smart Block' in 'SUPERBlock' »

Development of the SmartSurface

Since the smart surface is an autonomous unit that can be infinately aggregated, it is necissary for it to be structurally independent. Having said that, it will never exsist as a single unit, but a minimum domain must be set, to disseminate the principle of the continuous surface/mobius/utopia. Bearing that in mind, I have begun to look at more logical ways of connecting two units.

This module is based on the previous and two manners of aggregation are explored. The first is a basic stack, where the module is repeated horizontally and vertically. The second is similar but at each horizontal level there is a shift, thus the elevation is toggled.
basic_all.jpg

toggled_all.jpg

Comments (2)

damita:

dude this is really really beautiful ... maybe start combining the different ways in which you aggregrate the smart surface to create some variety, or are you looking for uniformity?? it appears that at the moment they aggregrate in a straight line ... (like it creates a straight wall)what happens when you put it into you block which is very curvaceous ...

natasha:

can you put your new maya model images online asap please!

Post a comment

(If you haven't left a comment here before, you may need to be approved by the site owner before your comment will appear. Until then, it won't appear on the entry. Thanks for waiting.)

About

This page contains a single entry from the blog posted on February 21, 2007 11:20 PM.

The previous post in this blog was Smart Surface.

The next post in this blog is Initial Renders with 'Smart Block' in 'SUPERBlock'.

Many more can be found on the main index page or by looking through the archives.

Powered by Movable Type 3.32
Hosted by LivingDot